A bench cease is a wonderful addition to any workshop. It is simply a elevated piece of wood that generates a lip to avert woodworking assignments from leaving the workbench.
So, if you are planing or belt-sanding a board, you never have to take the time to add clamps because the cease will do the identical position: avert the board from shooting off the conclusion of the workbench.
You can make an adjustable bench quit with almost nothing far more than a piece of 50 %-inch plywood. Slash a few of slots with a jigsaw, and then on the stop of the workbench put in two hanger bolts. I also additional a few of washers and wing nuts to maintain it in spot.
Then you just slip it in, and you can regulate it to the height
of your workpiece — any thickness.
When you’re viewing the video and you see the black line I place on there, that’s about 3-and-a-half inches previously mentioned the workbench, which happens to be the correct height of my observed table on the miter noticed.
This bench prevent does double-duty as do the job aid. So, the
lip also can prop up the conclusion of a board if you need it to do that.
You can adjust the bench halt to match your saw — that is one gain. The other fantastic point about this is, when you don’t want a bench end, just loosen up the wingnuts and it drops down out of the way!
video to see the Very simple Option!
Simple Solutions is introduced to you by Titebond, The Pros’ Gain.